Water Conservancy & Electric Power Machinery 2011 Issue 2 Analysis on electric field of wall bushing for 40.5 kV switch cabinet and optimized design

Analysis on electric field of wall bushing for 40.5 kV switch cabinet and optimized design
WANG Wenfeng;ZHANG Qingjie;JIANG Liqi

..............page:20-21,26

Treatment of leakage points of bypass flue in wet flue gas desulphurization system under the condition of it\'s without sut up gas-gas heater
NIE Pengfei;ZHANG Hongyu

..............page:70-73

Analysis and treatment on a unit trip-out accident caused by tripping of generator ground protection
ZHANG Xiaobing

..............page:37,40

Application of the three-point method for dynamic balance to pulverized coal exhauster
WANG Qingdong

..............page:33-34

Realization of \'four furnaces with one tower\' in semi-dry desulphurization project
QIU Gang;JI Chuanjun;MA Hongliang

..............page:66-69

Optimization of capacity increasing reformation scheme for desulphurization system of large thermal power generation unit
WANG Yong;WANG Zhidong;PEI Junyuan

..............page:18-19,23

Analysis of abnormal situation of rotor magnetic pole in 50 MW hydroelectric generator
CHAI Fangguang;CHENG Zhenwei

..............page:55-57

Characteristics of fuel control system of 600 MW supercritical boiler and optimization
QU Qijiu

..............page:49-52

Analysis on engineering project of water intake and outlet layout for coastal nuclear power plant
ZHOU Jinquan

..............page:8-14

Abstracts

..............page:78-81

Application of high-voltage variable-frequency speed control device in condensate pump
WU Baohua;LIU Hui

..............page:27-29

Application of DAS gland seal in reformation of 600 MW steam turbine
LIU Junling;LI Yongjun;ZHAO Tieying

..............page:4-5

Application of new-type gland seal in domestic 600 MW unit and economic efficiency analysis
FENG Renhai;YU Qiyun

..............page:60-61,69

Technical reformation of the final reheater of a boiler
LIU Ligang;GUO Jingling;YAN Changyou

..............page:22-23

Analysis on reasons of bearing vibration of 330 MW steam turbine in changeover from single valve mode into sequence valve mode
ZENG Qi

..............page:6-7,14

The application of the separated circuit in equipments with uninterruptible power supply
GUO Bochun

..............page:46-48,52

Induced draft fan type selection for 2×600 MW unit of Tongzi Power Plant
WANG Jie

..............page:15-17

Reformation and optimized operation of speed control system of boiler feed pump turbine
ZHAO Yuzhu;WANG Zhangsheng;XU Houda

..............page:30-32

Perfection of furnace safety supervision system
LI Xinjian

..............page:62-65,73

Analysis on reasons of electronic weighing coal feeder blockage
LIAN Yinghua

..............page:58-59,77

Analysis on reasons of abnormal oil dielectric dissipation factor and the treatments
WANG Hongming;LI Qingchang;SUN Chengjun

..............page:38-40

Application of three-point method for dynamic balancing in large-scale fan
FAN Wenbin

..............page:53-54,57

Application of coal blending technology in thermal power plant
XUE Tiezhu;HU Linmao

..............page:41-43,45

Management practice of concessionary operation of flue gas desulphurization
XU Huaibin;YANG Lijun;HU Chuntao;LI Yupeng

..............page:74-77

hua dian ji shu zheng gao qi shi

..............page:插1

Analysis on short-circuit fault and open-circuit fault of electrostatic precipitator in no-load voltage rising test
BO Zunjun

..............page:44-45

Reasons analysis and preventive measures on larger opening of normal drainage regulating valve of high-pressure heater
BI Yuheng;L(U) Pengfei;NI Guodong

..............page:24-26

Analysis on fault of steam drum water level indicator in initial start-up stage and prevention
GU Baoquan

..............page:35-36

Analysis on fracture reasons of last four-stage blade of steam turbine and treatment
DUAN Jipeng

..............page:1-3