1007-4554
2011 Issue 6
Research of Global Joint Development of Vehicle Project Management
Jin Liuqing;Kang Fei
Jin Liuqing;Kang Fei
..............page:26-30
..............page:62
..............page:1-3,12
Analysis of the Model of the Off-site Way to Return the Car
Chen Rongzhang;Chen Huaijuan
Chen Rongzhang;Chen Huaijuan
..............page:36-38
..............page:53-57
..............page:50-52,57
..............page:42-44
Topology Optimization Design for Beam of Typical Hydraulic Module Assembled Trailer with Six Axes
Zhang Zhongzheng;Ma Li;Zhang Yutan
Zhang Zhongzheng;Ma Li;Zhang Yutan
..............page:22-25
Analysis and Optimization Design of Thermostat Sealing Failure
Wang Kang;Gui Quan;Wang Yanjun
Wang Kang;Gui Quan;Wang Yanjun
..............page:45-49
Research of the Low-cost Vehicle Development
Chen Weiquan;Kang Fei
Chen Weiquan;Kang Fei
..............page:31-35
Analysis of the Collision Strength of Spot Weld, Adhesive, both Spot Weld and Adhesive Jointed Box Beams by Experiments
Liu Fei;Chen Junyi;Wang Hongyan
Liu Fei;Chen Junyi;Wang Hongyan
..............page:16-18
Summarize of Steering System for Fuel Cell Vehicle
Xie Zejin;Ling Tianjun
Xie Zejin;Ling Tianjun
..............page:4-8
Influence of Start of Injector to Mixture Process about Homogeneous GDI Engines in Low Speed
Ding Ning;Gao Weimin;Chen Ming
Ding Ning;Gao Weimin;Chen Ming
..............page:13-15,25
Design of Simulation Test Platform of Vehicle Controller for Plug-in FCV
Kou Gaihong;Liu Fen;Liang Weiming
Kou Gaihong;Liu Fen;Liang Weiming
..............page:9-12
Analysis of the Manufacturing Craftwork and Quality Control of Embedded Trim Board of Door Panel
Wang Yonghua
Wang Yonghua
..............page:58-61
..............page:39-41
Research of Durability Test Equipments of the Power Sliding Door for Vehicle
Xu Jici;Wang Yufeng
Xu Jici;Wang Yufeng
..............page:19-22