1001-2168
2010 Issue 3
Component technology-based design of progressive die under UG environment
xia li ying ; hu yun
xia li ying ; hu yun
..............page:27-31
..............page:32-35
General model file-based mould demo system
liu yu sheng ; zhang mei li
liu yu sheng ; zhang mei li
..............page:10-12
A novel idea for the design of parting surface of multihole and multinotch plastic part
xiao yan yan
xiao yan yan
..............page:55-58
Analysis of failure of extrusion die for the pedestal of oxygen lance nozzle
zhang li xia ; fang min
zhang li xia ; fang min
..............page:67-70
The wire cutting process of straight cutting edge of arc die
li shu bao ; peng wei zhu
li shu bao ; peng wei zhu
..............page:71-74
..............page:74-75
..............page:24-26
Pro/E-based design of die casting die for magnesium alloy shell body
lei li ; yu yan dong
lei li ; yu yan dong
..............page:59-62
Development trends and demand analysis of rapid tooling technology
liu hong jun ; li ya min ; cao chi
liu hong jun ; li ya min ; cao chi
..............page:63-66
A progressive die for 191° bending of terminal
yan zhi yong
yan zhi yong
..............page:19-23
Development of injection mould for water chamber
lin hai xiong ; kang jun yuan ; chen qiang ji
lin hai xiong ; kang jun yuan ; chen qiang ji
..............page:49-52
Design of no-lapping laminating and riveting progressive die for rotor, yoke and stator
zhao jian le ; zhao kai
zhao jian le ; zhao kai
..............page:13-18
Development of bending die for motor cycle side tube
yang hai peng
yang hai peng
..............page:38-40
..............page:31,75
Thermal analysis and optimization of mould for fully biodegradable dishware
lu hai ning ; jia xiu jie ; li jian feng ; li fang yi ; wang xia ; li jian yong
lu hai ning ; jia xiu jie ; li jian feng ; li fang yi ; wang xia ; li jian yong
..............page:45-49
Analysis on the drawing process of inner and outer panel of luggage compartment
huang wen wei ; zhou xiao yan ; zhao jian ; li xiang cheng
huang wen wei ; zhou xiao yan ; zhao jian ; li xiang cheng
..............page:36-38
..............page:1-5
Application of Moldflow in design of injection mould
sun li juan ; xing dong shi ; huang zhuan ; lin zuo zong
sun li juan ; xing dong shi ; huang zhuan ; lin zuo zong
..............page:41-44,62
Design of injection mould for special-shaped shaft sleeve
qiao nv ; wu zhi ming
qiao nv ; wu zhi ming
..............page:53-55
Study and application of 4Ps development system for mould programs
zhou yong quan ; miao miao ; liu bai
zhou yong quan ; miao miao ; liu bai
..............page:5-9