Journal of Shenyang University of Technology 2008 Issue 4 shen yang gong ye da xue xue bao wang zhan quan mian kai tong

shen yang gong ye da xue xue bao wang zhan quan mian kai tong

..............page:后插2

shen yang gong ye da xue xue bao tou gao xu zhi

..............page:后插1

Compressive strength of cement mortar under erosion of SO2-4and HCO-3
NING Bao-kuan;ZHENG Nan;CHEN Si-li;LIN Si-yuan

..............page:477-480

Numerical simulation on crash between W-beam semi-rigid guardrail system and vehicle
SHEN Xin-pu;GUO Li-li;DU Xian-he;LU Li-hua

..............page:472-476

Pressure ratio optimization analysis of Brayton cycle for HTGR
CAO Jian-hua;WANG Jie;YANG Xiao-yong;YU Su-yuan

..............page:466-471

Cylindrical panoramic image stitching method based on RANSAC algorithm
HUANG You-qun;FU Yu;MA Guang-kun

..............page:461-465

Iterative reconstruction of ECT image without using sensitivity matrix
YAN Hua;ZHANG Liang

..............page:457-460

Multi-channel data acquisition based on FPGA in magnetic flux leakage testing
YANG Li-jian;ZHANG Qing-bin;GAO Song-wei;WANG Xiao-gang

..............page:453-456

Geometry simulation and non-linear error analysis of free surfaces
ZHAO Wen-zhen;LIGang;ZHAO Wen-hui;DUAN Zhen-yun

..............page:449-452

Condition monitoring and fault diagnosis of gear box based on blind source separation
CHEN Chang-zheng;CHENG Jin-sheng;HAN Li-ya;LI Ming-hui;WANG Yin-long;ZHOU Bo

..............page:444-448

Microstructures of aluminized coatings on pure copper through thermal spray and diffusion treatment
ZHANG Zhong-li;ZHAO Jiao-yu;WANG Yan-yan;WANG Yi-hua;HE Chuan-jun

..............page:437-443

Microstructures and mechanical properties of extruded Mg-Zn-Nd alloys
WU Wei;ZHU Feng-yan;ZHOU Tie-jun;CHEN Li-jia;YANG Lin;LIU Zheng

..............page:433-436

Calculating and simulation for field emission tip electric potential of single-walled carbon nanotubes
GUO Lian-quan;HAN Dong;MA He;LIU Jia-hui;SONG Kai-yan;WU He-nan;WANG Shuai

..............page:429-432

Design of soft starting and speed regulator for belt conveyer
LI Wei;WANG Fan;LI Hai-bo;GAO Hong-yu

..............page:374-378,398

Nonlinear dynamic characteristics of magnetic suspended rotor system
BAO Wen-bo;LI Na;WANG Feng-xiang

..............page:370-373

Simulation of flat-plate gas discharge based on fractal theory
CAO Yun-dong;YUAN Dong-sheng;LIU Xiao-ming

..............page:366-369

Multi-phase rectifying system using phase-shifting reactor
WANG Feng-xiang;ZHANG Tao;BAI Hao-ran

..............page:361-365,393

Optimization of laser micromachining parameters for biomedical titanium
ZHANG Song;HU Jin-ling;WANG Qiang;ZHANG Chun-hua;LIU Chang-sheng

..............page:424-428

Tensile deformation behavior of hot-extruded AZ81 magnesium alloy
CHEN Li-jia;MAO Liang;ZHANG Si-qian;MA Chun-yan;LI Feng

..............page:419-423,428

Computer simulation of atom distribution during initial aging stage of Al-4.0Cu alloy
LI Rong-de;MA Huan-huan;LI Run-xia;QU Ying-dong

..............page:414-418

Analysis of extreme wind conditions in load calculation of wind turbines
LI Yuan;MAO Zhu

..............page:409-413

Power characters of 1 MW wind turbine rotor
DENG Ying;REN Li-na;LIU Li-jun;LIANG Jing-jing

..............page:404-408

Control strategy and system development of direct drive VSCF wind turbine
YAO Xing-jia;BAO Jie-qiu;LI Wei;LIU Ying-ming;LI Guang-bo

..............page:399-403,408

Integrated optimal planning approach of distribution network
WANG Yan-jie;YI Tao

..............page:394-398

Influence of electromagnet inductance on rapidity of hybrid magnetic suspension system
LIANG Zhong-hua;LI Qing-jiang;WU Hong-bo

..............page:389-393

Specific absorption rate distribution of electromagnetism radiation for hyperthermia treatment of breast cancer
BAI Bao-dong;WEN Bo

..............page:384-388

Sliding mode control for PMLSM based on singular perturbation
SUN Yi-biao;YUAN Xiao-lei;BAO Yan-feng

..............page:379-383