Coal Engineering 2016 Issue 8 Mining technology research for fully mechanized working face with annual output of 15 million tons

Mining technology research for fully mechanized working face with annual output of 15 million tons
ZHANG Li-hui;

..............page:1-3,7

Reasonable width of section coal pillar under mining influence of hard and thick roof
PEI Xiao-jian;,XU Jin-hai;,LIU Tao;

..............page:4-7

Research on strip mining based on long-wall and short-wall mining
SUN Qing-xian;

..............page:8-11

Non pillar gob-side entry retaining mining with roof cutting pressure releasing in Tangshangou coal mine
MAO Huai-yong;

..............page:12-14

Research on setting method of emergency lane for trackless tyred vehicle shaft
WANG Li-xin;,CHEN Yun;,JIA Yan-nan;

..............page:15-17

Design and selection of main shaft equipment in Mengcun coal mine
SUN Dong-fei;,ZAN Dong-feng;,WANG Tong-guang;

..............page:18-21

Design and application of coal mine belt conveyor monitoring system based on serial fieldbus protocol
SHE Ying;

..............page:22-24

Force analysis and calculation of vertical shaft discharge pipeline supporting beams
WANG Wen;

..............page:25-27,30

Influence of differential foundation settlement on steel headframe
LU Zhong-ke;,MA Zhong-cheng;

..............page:28-30

Application of Bentley 3D collaborative software in coal preparation plant design
ZHENG Yuan;

..............page:31-32,36

Application of rapid excavation technology in high cutting open-off roadway with large section
HU Shao-xuan;

..............page:33-36

Control technology of roadway with rheological surrounding rock in complex tectonic stress area
ZHANG Jun-min;,ZHANG Wei-guang;

..............page:37-39

Support technology of high cutting working face crossing abandoned roadway in coal and gas outburst coal mine
SONG Bin;

..............page:40-42

Development and application of new type waterproof anchorage agent
WANG Zheng-sheng;

..............page:43-45,49

Secondary grouting technology in remained roadway at high cutting working face
XIONG Zu-qiang;,ZHANG Jian-feng;

..............page:46-49

Scouring zone crossing technology in high cutting fully mechanized face of Bulianta coal mine
CHI Guo-ming;

..............page:50-53

Study on characteristics of coal wall spalling in high cutting fully mechanized working face in Sihe coal mine
AN Ze;

..............page:54-56,60

Feasibility study on 3# coal seam mining above hollow in Haitian coal mine
LIU Xu-feng;,XIONG Zu-qiang;

..............page:57-60

Research on withdrawing and installation of coal mining equipment in fully mechanized top coal caving face with large mining height
TIAN Hua;

..............page:61-63,67

Strata behavior law of high cutting backfill mining with high water material in deep mine
ZHANG Han-xiong;,HUANG Yu;,HUANG Xiao;,XIE Guo-qiang;,YANG Jun-hui;

..............page:64-67

Voice frequency electric perspective and treatment technology for goaf water in upper seam of close-distance coal seams
WANG Zhen-hai;

..............page:68-70

Design of roof-to-floor convergence sensor based on laser ranging
LIU Ya-hui;

..............page:71-73

Effect of fault on height of water-flowing fracture zone in steep mining face with soft overlying strata
ZHANG Wei-min;,YANG Gang-shuai;

..............page:74-76,80

Deformation characteristics and pressure-relief control technology of floor roadway under overlying coal seam mining pressure
ZHAO Qi-feng;,WANG Bo;,ZHENG Si-da;,SHI Jian-jun;,LIU Yuan-yuan;

..............page:77-80

Characteristics of mine pressure behavior in initial working face with slope-adjustment mining
NIU Qin-huan;,LI Dong-wei;,WANG Teng;,LI Ya-nan;

..............page:81-84

Experimental study of gas pressure influence to seepage characteristics of two different coal samples
SUN Guang-zhong;,GUO Bing-bing;,WANG Gong-zhong;,ZHANG Rui-lin;

..............page:85-88

Experimental study on gob three-dimensional flow field of "U+L" ventilation system
CAI Jia-wen;,YANG Sheng-qiang;,JIAO Han-lin;,QIN Yi;

..............page:89-92

Research on 4-quadrant converter of mine shearer
DENG Yong-hong;,LI Xiao-ping;,ZHAO Li-yong;,HUANG Cheng-yu;

..............page:93-95,99

Detection method of hoist motor vibration signal based on correlation differential resonator array
LI jing-ya;,WEI Hong;

..............page:96-99

Mining equipment fault diagnosis based on motor current signal and EEMD decomposition
CAO Xiang-hui;,ZHANG Zheng-kai;,LI Sheng-li;

..............page:100-102

Calculation of condenser cooling water resistance for coal mine refrigeration system
WANG Lei;

..............page:103-105,109

Evaluation of CO2 geological storage potential on main coalfields in China
ZHENG Chang-yuan;,ZHANG Hui;,JIA Xiao-feng;,FANG Zhi-ming;

..............page:106-109

Inhibition mechanism of fine coal fractions on coarse coal flotation
HOU Shi-yu;,MA Li-qiang;,BAI Yun-peng;,SUN Chao;

..............page:110-113

Experimental study on low-temperature drying characteristics of subbituminous coal
BAI Pu;,XU Cheng;,XU Gang;,MA Ying;,DONG Wei;,GUO Yan;

..............page:114-116

Analysis on synergistic effect and kinetics of co-pyrolysis of floatation tailings and pine
LI Yu-huan;,ZHAO Hong-yu;,LIU Shu-cheng;,SONG Qiang;,LIANG Xin-xing;,DU Xin-yu;,SHU Xin-qian;

..............page:117-120

Experimental study on low-temperature oxidation characteristics of coal in pulverized-coal industrial fired boiler
WEI Yan-rong;,XIAO Cui-wei;,WANG Nai-ji;,YANG Shi;

..............page:121-124

Experimental study on frost resistance of high performance concrete mixed with slag powder
FENG Meng-chao;,LI Rui-jing;,ZHANG Xue-qing;,ZHANG Xuan;,MA Lin-lin;

..............page:125-127

Characteristic analysis of chemical elements and pyrolysis of coal gangue in Ulan Mulun mining area
LIU Yue;,XU Qing-yun;

..............page:128-131

Development and application of ZYWL-4000D economic directional drilling rig
YAN Bao-yong;

..............page:132-134

Design of PWM generator based on FPGA
ZHA Guo-xiang;,MA Yong;,WANG Cong;

..............page:135-137,140

Application of semi-trailer fifth wheel in coal chock trailer
YAO Zhi-gong;,PAN Cheng-jie;

..............page:138-140

Professional synergetic management and control mode of major hazard sources of coal mine gas
CHENG Jian-sheng;

..............page:141-143

Thoughts on team building of coal prospecting and design enterprise engineering
CUI Rong;

..............page:144-145,148

Discussion on key points of technical bid and business bid in engineering equipment bidding
LI Hai-ying;

..............page:146-148

kan shou yu
mei tan gong cheng za zhi she ;

..............page:前插1