1000-9361
2015 Issue 5
..............page:0-0
Horn-Schunck optical flow applied to deformation measurement of a birdlike airfoil
Gong Xiaoliang;,Stephan Bansmer;
Gong Xiaoliang;,Stephan Bansmer;
..............page:1305-1315
Large eddy simulation of hydrogen/air scramjet combustion using tabulated thermo-chemistry approach
Cao Changmin;,Ye Taohong;,Zhao Majie;
Cao Changmin;,Ye Taohong;,Zhao Majie;
..............page:1316-1327
A reduced order aerothermodynamic modeling framework for hypersonic vehicles based on surrogate and POD
Chen X in;,Liu Li;,Long Teng;,Yue Zhenjiang;
Chen X in;,Liu Li;,Long Teng;,Yue Zhenjiang;
..............page:1328-1342
Autonomous gliding entry guidance with geographic constraints
Guo Jie;,Wu Xuzhong;,Tang Shengjing;
Guo Jie;,Wu Xuzhong;,Tang Shengjing;
..............page:1343-1354
A new surface catalytic model for silica-based thermal protection material for hypersonic vehicles
Li Kai;,Liu Jun;,Liu Weiqiang;
Li Kai;,Liu Jun;,Liu Weiqiang;
..............page:1355-1361
Shock wave configurations and reflection hysteresis outside a planar Laval nozzle
Wang Dan;,Yu Yong;
Wang Dan;,Yu Yong;
..............page:1362-1371
Experimental investigations on cavity-actuated under-expanded supersonic oscillating jet
Sun Bo;,Luo Xiaochen;,Feng Feng;,Wu Xiaosong;
Sun Bo;,Luo Xiaochen;,Feng Feng;,Wu Xiaosong;
..............page:1372-1380
Microjet flow control in an ultra-compact serpentine inlet
Da Xingy;,Fan Zhaolin;,Fan Jianchao;,Zeng Liquan;,Rui Wei;,Zhou Run;
Da Xingy;,Fan Zhaolin;,Fan Jianchao;,Zeng Liquan;,Rui Wei;,Zhou Run;
..............page:1381-1390
An improved adaptive sampling and experiment design method for aerodynamic optimization
Huang Jiangtao;,Gao Zhenghong;,Zhou Zhu;,Zhao Ke;
Huang Jiangtao;,Gao Zhenghong;,Zhou Zhu;,Zhao Ke;
..............page:1391-1399
Dynamic stiffness testing-based flutter analysis of a fin with an actuator
Zhang Renjia;,Wu Zhigang;,Yang Chao;
Zhang Renjia;,Wu Zhigang;,Yang Chao;
..............page:1400-1407
..............page:1408-1415
Development of swashplateless helicopter blade pitch control system using the limited angle direct-drive motor (LADDM)
Wang Jian;,Wang Haowen;,Wu Chao;
Wang Jian;,Wang Haowen;,Wu Chao;
..............page:1416-1425
Dynamic characteristics of a cyclic-periodic structure with a piezoelectric network
Li Lin;,Deng Pengcheng;,Fan Yu;
Li Lin;,Deng Pengcheng;,Fan Yu;
..............page:1426-1437
A distributed cooperative guidance law for salvo attack of multiple anti-ship missiles
Zhang Youan;,Wang Xingliang;,Wu Huali;
Zhang Youan;,Wang Xingliang;,Wu Huali;
..............page:1438-1450
On-orbit real-time robust cooperative target identification in complex background
Wen Zhuoman;,Wang Yanjie;,Arjan Kuijper;,Di Nan;,Luo Jun;,Zhang Lei;,Jin Minghe;
Wen Zhuoman;,Wang Yanjie;,Arjan Kuijper;,Di Nan;,Luo Jun;,Zhang Lei;,Jin Minghe;
..............page:1451-1463
Fault tolerant control with torque limitation based on fault mode for ten-phase permanent magnet synchronous motor
Guo Hong;,Xu Jinquan;
Guo Hong;,Xu Jinquan;
..............page:1464-1475
Hardware-in-the-loop simulation technology of wide-band radar targets based on scattering center model
Huang Hao;,Pan Minghai;,Lu Zhijun;
Huang Hao;,Pan Minghai;,Lu Zhijun;
..............page:1476-1484
Difference beam aided target detection in monopulse radar
Cai Fei;,Fan Hongqi;,Song Zhiyong;,Fu Qiang;
Cai Fei;,Fan Hongqi;,Song Zhiyong;,Fu Qiang;
..............page:1485-1493
Active control for performance enhancement of electrically controlled rotor
Lu Yang;,Wang Chao;
Lu Yang;,Wang Chao;
..............page:1494-1502
On-orbit real-time magnetometer bias determination for micro-satellites without attitude information
Zhang Zhen;,Xiong Jianping;,Jin Jin;
Zhang Zhen;,Xiong Jianping;,Jin Jin;
..............page:1503-1509
A new iterative algorithm for geolocating a known altitude target using TDOA and FDOA measurements in the presence of satellite location uncertainty
Cao Yalu;,Peng Li;,Li Jinzhou;,Yang Le;,Guo Fucheng;
Cao Yalu;,Peng Li;,Li Jinzhou;,Yang Le;,Guo Fucheng;
..............page:1510-1518
Dynamic attack zone of air-to-air missile after being launched in random wind field
Hui Yaoluo;,Nan Ying;,Chen Shaodong;,Ding Quanxin;,Wu Shengliang;
Hui Yaoluo;,Nan Ying;,Chen Shaodong;,Ding Quanxin;,Wu Shengliang;
..............page:1519-1528
Imaging the interphase of carbon fiber composites using transmission electron microscopy:Preparations by focused ion beam, ion beam etching, and ultramicrotomy
Wu Qing;,Li Min;,Gu Yizhuo;,Wang Shaokai;,Zhang Zuoguang;
Wu Qing;,Li Min;,Gu Yizhuo;,Wang Shaokai;,Zhang Zuoguang;
..............page:1529-1538
Surface integrity of GH4169 affected by cantilever finish grinding and the application in aero-engine blades
Li Xun;,Ma Shuang;,Meng Fanjun;
Li Xun;,Ma Shuang;,Meng Fanjun;
..............page:1539-1545
Mechanics analysis of axisymmetric thin-walled part in warm sheet hydroforming
Yang Xiying;,Lang Lihui;,Liu Kangning;,Liu Baosheng;
Yang Xiying;,Lang Lihui;,Liu Kangning;,Liu Baosheng;
..............page:1546-1554
Tool path planning based on conformal parameterization for meshes
Zhao Jibin;,Zou Qiang;,Li Lun;,Zhou Bo;
Zhao Jibin;,Zou Qiang;,Li Lun;,Zhou Bo;
..............page:1555-1563
Positioning method of a cylindrical cutter for ruled surface machining based on minimizing one-sided Hausdorff distance
Cao Lixin;,Dong Lei;
Cao Lixin;,Dong Lei;
..............page:1564-1573
Placement suitability criteria of composite tape for mould surface in automated tape placement
Zhang Peng;,Sun Ronglei;,Zhao Xueying;,Hu Lingjin;
Zhang Peng;,Sun Ronglei;,Zhao Xueying;,Hu Lingjin;
..............page:1574-1581
..............page:1582-1582
..............page:1583-1583
..............page:1584-1584